Dead-ends guy grips to protect preformed ADSS & OPGW cable

The preformed dead-ends guy grips can protect and provide cushioning to preformed ADSS & OPGW cable. The special design of helical rods makes ensure that preformed dead-ends can not cause undue stress to the OPGW cables, so that the normal lifetime of cable system is ensured.

preformed dead-ends guy grips

Structure and Raw Material of dead-ends guy grips
1. Anchor Shackle: Hot dipped galvanized steel. Anchor Shackle is connected with fastener clamp on tensile pole (or tower).
2. Extension Link: Hot dipped galvanized steel. Parallel Plate is connected Anchor Shackle and Clevis Thimble.
3. Clevis Thimble: Hot galvanized cast steel. Clevis Thimble is plugged in bend of Outer Reinforcing Rods for protection and connected.
4. Inner reinforcing Rods: Inner reinforcing rods are made of aluminium clad steel rods. With a layer of particle emery inside, Inner Protection Rods can increase friction and decrease side pressure to cables. Rods are made into four subsets which can reduce misalignment errors and speeds installation. The ends are bent outward to avoid stress to OPGW cables.
Outer dead-end Rods: Rods are made into one subset with a layer of firm emery inside, in order to increase gripping power of Outer Reinforcing Rods while decreasing side pressure. Sets are color marked to reduce misalignment errors and to speed installation
5. Ground clamp: Aluminum alloyDSS & OPGW cable. The special design of helical rods makes ensure that preformed dead-ends can not cause undue stress to the OPGW cables, so that the normal lifetime of cable system is ensured.

This article comes from http://www.preformedfittings.com/Product/